Sensors are available with VR or Hall technologies with cable or connector interfaces. Sizes range from 3/8-24 and M10X1 to 3/4-16 and M16X1.5. Sensor capability ranges from zero speed to high frequency detection and all units have sealed sensing areas to prevent liquid intrusion. Also available are direction sensing units and hazardous location versions for both North America (NEC, CEC) and Europe (ATEX)
Differential Hall Effect Pick Up
Additional Information
| option | Hall Effect |
|---|
Documentation
Product Description
The D12 series differential Hall effect speed sensors are suitable, in conjunction with a ferrous pole wheel, for generating square wave signals proportional to rotary speeds. They exhibit a dynamic function, whereby pulse generation down to 5 Hz is guaranteed. The sensor must be oriented with respect to the pole wheel as shown in the dimensional drawing.
Technical data
Supply voltage: 8…32 VDC, protected against reverse polarity 8…32 VDC, protected against reverse polarity
Current consumption Max. 15 mA (without load)
Signal output Square wave signal from push-pull output stage, DC-coupled to the supply
(negative pole = reference voltage), max. load current 30 mA
Square wave signals
Push-pull outputs: Imax = ± 20 mA
With pull-up resistor (for R=560 Ohm): Ulow < 2.5 V, Uhigh > 0.95 * Usupply
With pull-down resistor (for R=560 Ohm): Ulow < 0.1 V, Uhigh > Usupply-4.0 V
The outputs are short-circuit proof and protected against reverse polarity.
Frequency range: 5 Hz…20 kHz
Housing M12x1, tightening torque: max. 12 Nm
Connection Cable with connector:
Cable: 3-wire, 3 x 0.21 mm2 (AWG24), stranded wires, PTFE isolation, green
casing, max. outer Ø = 3.9 mm, min. bending radius = 60 mm, cable length
according to dimensional drawing
Connector: AMP 282105-1, 3 pins
Operating temperature: -40°C…125°C
Protection Sensor head: IP68
Connector: IP67
Related Products
Your browser is out-of-date!
Update your browser to view this website correctly.Update my browser now